Skip to content
English - United States
CONTACT US
  • There are no suggestions because the search field is empty.

How to Add a Replacement Pod to Your Existing Set

When you receive a replacement pod or pods, you must set them up together with all the pods already in your set.

Step 1: Prepare Your Existing Pods

  1. Place all your existing pods on the charger.
  2. Turn them on.
  3. Open the Sportreact app.
  4. Go to Settings → Pods → Setup.
  5. Tap Switch Connected.

Your existing pods should enter Setup Mode and display a blue screen.

Step 2: Prepare the Replacement Pod

Turn on the replacement pod.

It should already display a blue screen. In the event it does not:

  1. Press and hold the power button.
  2. Continue holding it while the screen fills red. As soon as the red covers the screen, release.
  3. The pod will display a green screen, a blue screen and will then shut off.
  4. Turn it back on and confirm that it displays a blue screen.

All pods, including the replacement pod, should now show a blue screen.

Step 3: Set Up the Complete Set

  1. Remove all pods from the charger.
  2. Place them together on a table.
  3. In the app, under Settings → Pods → Setup, tap Next.
  4. Tap Next again.
  5. Wait for the app to find all the pods.
  6. Once every pod appears, tap Setup.
  7. Follow the remaining instructions in the app.

During setup, the pod screens will turn green and each pod will receive a number.

Step 4: Finish and Sync

Once the setup is complete:

  1. Tap Connect.
  2. Tap Finish and Sync normally.

Your replacement pod is now part of your existing set and ready to use.

 

If a blue screened pod is NOT detected by the app:

Press and hold the pod’s power button for approximately 45 seconds- keep holding despite all noises or screen changes- then release it.

After the reset, repeat the steps above to return the pod to Setup Mode (the bue screen) if it is not already, and continue with reconnecting to the complete set.